Uee923 Three Calibration Magnetic Paint Thickness Gauge CE FCC
Certified
High Precision Build-In Thermal Printer Three Calibration Paint
Coating Thickness Gauge
Features & Functions
● All products like Uee923 are CE, FCC certified & manufactured
according to ISO 9001.
● It can work continuously for ten hours due to the rechargeable
lithium ion battery
● The Large memory can save 4 kinds of materials and 1560 test
values.
● Uee923 provide three kinds of easy calibration ways as below:
(1) by one specimen (2)two specimens (3) five specimens
● Uee923 has software to connect PC for data transmission,
analysis, and printing measurement reports.
● It is convenient because of the built-in thermal printer(Width of
printer paper: 56.5±0.5mm).
● Uee 923 has five kinds of statistics: Average, Maximum, Minimum,
Testing times, Standard deviation.
● As the leading manufacturer, we support 3 years warranty and
life-long services.
Technical Parameters
| Technical Parameters |
| Model | Uee923 |
| Measuring principle | Magnetic induction (Fe ) & Eddy current ( NFe) |
| Measuring range (µm) | 0~1250μm |
| Accuracy | ±(1%H+1) μm; H refers to the thickness of testing piece |
| Minimum resolution (µm) | 0.1μm |
| Min curvature of the min area (mm) | Convex1.5 Concave9 |
| Diameter of the min area (mm) | Φ7 |
| Critical thickness of substrate (mm) | 0.5 |
| Operating temperature | 0℃~40℃ |
| Memory | 1560 |
| Dimensions | 238*90*38mm |
| Weight | 420g |
| Printer | Build-in High-speed Thermal Printer |
| Power supply | Rechargeable Li-ion battery |
| Standard Configuration | Main Machine, probe*1(Fe or NFe), substrate*1(Fe or NFe), software
& USB, Calibration specimens*5, Users’ Manual, Qualified
Certificate, Paper for Printer, Power Charger, Packing list,
Warranty card |
| Optional Accessories | Probes, Specimens, Paper for printer |
The Rules when using the instruments
a) The characteristics of substrate
Standard methods for magnetic substrate of magnetic properties and
surface roughness should be similar to the magnetic properties and
surface roughness of specimens substrate.
For eddy current method, the standard substrate of electrical
properties should be similar to the electrical properties of
specimens substrate.
b) The thickness of substrate
Check whether the thickness of the substrate is lower than the
minimum thickness, if not, can use one of method in 3.3 to
calibrate.
c) Edge effect
Should not be in the specimen shape changing places, such as
edges,holes, and the place such as Angle measurement.
d) The curvature
Should not be in curved surface measurement of the specimens.
e) Measurement and measured times
Usually as a result of the instrument measurement result is not the
same each time, so we must in every area from several measurement
results.Coating thickness and surface rough degree of local
differences, require at any repeated measurements in a specific
area.
f) Surface cleanliness
Before measurement, should remove any attached on the surface of a
material, such as dust, grease and corrosion products, but do not
remove any covering material.
5 calibration specimens: 48.5μm,99.8μm,249μm,513μm,1024μm
Packing box: High quality water-proof box
